The USAlert WatchDog Pager Belt Clip is a detachable part of the WatchDog Pager housing. Made of the same rugged polycarbonate material as the WatchDog Pager, the Belt Clip is designed for quick and easy removal of the pager from a belt when receiving or playing back messages. Individual replacement Belt Clips can be ordered if the original is ever damaged or lost. Since the Belt Clip is detachable, there is no need to send the entire pager back for repair.
The USAlert WatchDog LT Pager Belt Clip is a standard piece of the LT pager. Made of the same durable polycarbonate material as the housing, the Belt Clip is designed to attach securely to a belt and also allow the pager to be quickly and easily removed from the belt when receiving a message. With the inherent twisting and pulling forces the Belt Clip must handle, it will sometimes become damaged and need to be replaced. The detachable Belt Clip can be removed from the pager and a replacement ordered, no need to send back the entire pager for repair.
The TPL Birdy WP Belt Clip is included and shipped with each Birdy WP POCSAG and Flex Pager. An exception is the Birdy WP POCSAG ATEX intrinsically safe pager that ships with a clear plastic holder instead. The spring-loaded detachable belt clip is made of the same rugged plastic material as the pager housing. Replacement belt clips can be ordered if ever lost or damaged.
The TPL Birdy Slim Alphanumeric Pager Belt Clip is a detachable accessory for the Birdy Slim pager that is made of the same durable material as the housing. Although the belt clip is included with each Birdy Slim pager, it can be removed if an alternative leather or textile carrying case is preferred. A replacement belt clip can be ordered if ever lost or damaged.
The USAlert NP35 Pager Belt Clip comes standard with every NP35 Numeric Pager. It is designed to allow easy removal of the pager from a belt to read or recall messages. Since it is detachable, individual Belt Clips can be ordered to replace any that may have been damaged or lost without having to send the pager back for repair. The Belt Clip can be released from the locking mechanism by using a small flat head screwdriver or similar device to pull the square plastic tab at the top of the clip away from the pager while also pushing up on the bottom of the Belt Clip. To attach a Belt Clip, fit it into the semi-circular slot on the back of the NP35 and slide it down until it “clicks” into place.